Faculty/Staff

Atek Projector Presentation Remote

11 views January 5, 2017 January 6, 2017 admin 0

What should I do if there are multiple Stagehand remote controls in use in close proximity to each other and the signal of one is interfering with another?

How to Reprogram the Remote Control

To change the ID code and channel on the remote control, push and hold AT THE SAME

TIME, without releasing, the following buttons for more than two seconds:

-Laser button

-Up button

-Down button

-Function button

(Not the LED illumination light button)

The LED illumination light will flash three times to confirm the change.

Note: This procedure is purposely designed to be somewhat physically awkward so as to decrease the chance of unintentional reprogramming. The easiest way to push these four buttons simultaneously is to lay the remote control flat on a table or to hold it in your hands like a clarinet with the LED illumination light (not laser beam!) facing you.

IMPORTANT: After you reprogram the remote control, you must also reprogram the USB receiver to learn the remote control’s new ID code and channel (with or without erasing the old ID code and channel) or to accept all ID codes and channels, per the instructions below

How to Pair the Remote with the Receiver

If you are reprogramming for the purpose of avoiding conflicts, read the above section to first erase all ID codes and channels

1.) With the USB receiver plugged into the powered on computer, take a narrow instrument, such as the uncurled end of a paperclip, and push and hold the reprogram button on the USB receiver until the LED indicator on the receiver (not the LED illumination light on the remote control) flashes two times.

2.) Then quickly release the button within 1.5 seconds.

3.) Next, push the up button or down button on the remote control several times so that the USB receiver can receive signals from the remote control.

If the LED on the receiver flashes when you send signals, this indicates that the receiver has learned the new ID code and channel. It will still respond to its original and any previously added ID codes and channels as well (as long as you have not erased them per the procedure described further below).

Note: The receiver will abandon the process of adding a new ID code and channel if you wait more than 15 seconds to send a signal from the remote control or if you unplug the receiver. Also, since the receiver will not add the ID code and channel of a remote control it already is actively programmed to recognize, if you send a signal from your currently recognized remote control(s), the LED on the receiver will not accept it and will not flash during this 15 second reprogramming period.

FAQs: http://wireless-presenter.com/stagehand-faq/

User Manual: http://wireless-presenter.com/wp-content/uploads/2012/09/Stagehand.pdf

Was this helpful?

Leave A Comment

*
*


Chat with our team

Have questions?
Chat with an expert!
CHAT WITH AN EXPERT

New Chat

SUBMIT A TICKET